7 Series E38 740i (M62) SAL
Remove rubber mount with special tool 33 3 312 / 314 / 315
and 33 4 162 / 161.
Coat bearing sleeve in rear axle carrier and rubber mount with
Circolight, refer to BMW Parts Service.
Slide rubber mount from side with larger diameter into special tool
33 4 165.
(1)
When drawing in rubber mount, milled recess locates at top
of rear axle carrier.
Caution!
The slotted side of the rubber mount must be at right angles
to groove in special tool 33 4 165.
Draw rubber mount in firmly with special tool 33 3 314 / 315
and 33 4 164 / 165 / 166.
Note:
Rubber mount must locate flush in rear axle carrier. If
necessary, rotate special tool 33 4 164 through 90
°
and
draw in overlap.
RA Replacing all rubber mounts on front and rear final drive mounts
BMW AG - TIS
12.02.2013 19:09
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -