7 Series E38 740i (M62) SAL
Cut out sound insulation in marked areas.
Note:
Retaining lugs on ITS head airbag gas generator must rest
flat on bulkhead cross-member and no sound insulation must
be jammed!
Position new gas generator.
Connector (3) of ITS head airbag gas generator (1) must not rest
on sound insulation (3) or be under tension.
Retaining lugs on ITS head airbag gas generator (2) must rest on
edge of bulkhead cross-member (1).
Distance (A) = 21 mm from edge of holder for instrument panel
trim (1) to center of bore hole of retaining lugs on ITS head airbag
gas generator (2).
Mark out position of retaining lugs on ITS head airbag gas
generator on bulkhead cross-member (3).
Remove ITS head airbag gas generator.
RA Removing and installing / replacing left or right ITS head airbag (model without
BMW AG - TIS
13.02.2013 02:47
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -