7 Series E38 740iL (M62) SAL
Note:
The continuity test with the multimeter described in the following is
not possible on the M62 B46 because of the different design of
the camshaft adjustment unit.
The remaining procedure is identical.
Connect a commercially available multimeter to a contact pin on
camshaft adjustment unit and to the screw connection on oil line
on cylinder bank 5 to 8.
Set multimeter to acoustic continuity test.
Attach special tool 11 6 440 to camshaft adjustment unit on
cylinder bank 5 to 8 and move at 40 Nm to left-hand stop.
Check left-hand stop of camshaft adjustment unit with acoustic
continuity test on multimeter.
Note:
Rotating the camshaft adjustment unit at 40 Nm to the left-hand
stop ensures that the end position is reached and there is no
longer an "oil cushion" before the left-hand stop of the camshaft
adjustment unit.
In the camshaft adjustment unit, there are three contacts which
are closed when the unit is at the left-hand stop.
During the acoustic continuity test with the multimeter, a sound
signal can be heard when the camshaft adjustment unit is at the
left-hand stop.
RA Removing and installing/replacing right camshaft adjustment unit (M62 VANOS from
BMW AG - TIS
17.02.2013 15:54
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 10 -