7 Series E38 740iL (M62) SAL
If necessary, remove non-return valve.
Insert commercially available screw with M10x1 thread or special
tool 13 5 132 as and extraction aid by hand in non-return
valve (1) and carefully remove.
Installation:
Replace sealing ring (1) on non-return valve.
Caution!
Check installed direction.
An incorrectly installed non-return valve will result in engine
damage.
Install non-return valve with M10x1 thread facing outwards.
Installation
Installation of the camshaft adjustment unit distributor is described
separately from removal.
Check correct installation position of non-return valve (1).
Feed in new gasket so that it is secured in groove on camshaft
bearing cover and over non-return valve (1).
RA Removing and installing/replacing distributor on left camshaft adjustment unit (
BMW AG - TIS
17.02.2013 15:55
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -