7 Series E38 740iL (M62) SAL
Check correct installation position of non-return valve (1).
Feed in new gasket so that it is secured in groove on camshaft
bearing cover and over non-return valve (1).
Make sure that contact points on plain compression rings snap
into place.
Align contact points of compression rings upwards.
Make sure that gasket is secured in groove on camshaft bearing
cover.
Apply a light coat of oil to camshaft adjustment unit distributor and
plain compression rings.
Carefully push on camshaft adjustment unit distributor so that it is
straight.
RA Removing and installing/replacing distributor on right camshaft adjustment unit
BMW AG - TIS
17.02.2013 15:55
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
