7 Series E38 740iL (M62) SAL
On cars with latent heat accumulators, do not turn on ignition
when filling cooling system.
Follow venting procedure specified in MG64,
refer to 64 12 ...
On vehicles with M52 engines, also unfasten additional vent
screw.
Note:
Turn on ignition. Set heater control to maximum temperature.
Set blower to low level. This opens the heating valves and
sets the auxiliary water pump in operation.
Perform filling operation slowly.
Fill up expansion tank fully and wait until bubble-free coolant
emerges from vent plug. Tighten down vent plug.
Note:
Use only recommended coolant,
refer to BMW Operating Fluids MG 17.
M62
Note:
Turn on ignition. Set heater control to maximum temperature.
Set blower to low level. This opens the heating valves and
sets the auxiliary water pump in operation.
Perform filling operation slowly.
Fill up expansion tank fully and wait until bubble-free coolant
emerges from vent plug. Tighten down vent plug.
Note:
Use only recommended coolant,
refer to BMW Operating Fluids MG 17.
RA Draining and topping up coolant
BMW AG - TIS
17.02.2013 17:04
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
