7 Series E38 740iL (M62) SAL
33 32 071
Replacing one upper control arm
Note:
If the control arm is detached from the rear axle carrier, it is
necessary after reinstallation to carry out a wheel/chassis
alignment check.
Necessary preliminary tasks:
•
Remove rear wheel.
•
Remove spring strut shock absorber from wheel carrier
Unfasten nut.
Installation:
Replace self-locking nut.
Tighten bolt connection in normal position.
Tightening torque 33 32 14AZ
.
Release nut and remove control arm.
Installation:
Keep control arm to wheel carrier connection clean and free from
oil and grease.
Replace self-locking nut.
Tightening torque 33 32 8AZ
.
RA Replacing one upper control arm
BMW AG - TIS
18.02.2013 00:11
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -