7 Series E38 740iL (M62) SAL
Fit spare outer section to wheel arch - separating point on C pillar
- mark out inner section.
Caution!
Take account of material allowance for offset!
Separate spare part at connection points.
Note:
If possible, manufacture reinforcement plate from metal scrap
from spare part.
Manufacture reinforcement plate for side member cover and
adjust to fit.
Reinforcement plate width = approx. 60 mm
Drill holes for plug welding the reinforcement plate in the side
member cover.
Clean connection point in side member cover and reinforcement
plate.
Coat reinforcement plate and connection point in side member
cover with zinc dust paint.
Insert reinforcement plate approx. 30 mm into cover for side
member and weld up.
Offset spare wheel arch - outer section with C pillar - inner section
and clean contact area.
Clean connection point on spare wheel arch - outer section and
coat with zinc dust paint.
Coat connection point on vehicle with zinc dust paint.
RA Replacing outer section of left or right rear wheel housing (side panel removed)
BMW AG - TIS
18.02.2013 02:04
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
