7 Series E38 740iL (M62) SAL
Determine location and mark cutting line on C-pillar.
Dimension (A) = 270 mm measured from end of gutter.
Remove foam rubber support, expose welding surfaces.
Caution!
If vapours arise when the foam is removed, extract them and
ensure that the area is well ventilated.
Drill out welding spots and remove C pillar.
Define separating point between wheel arch - outer section / C
pillar - inner section and mark out.
Dimension (A) = 290 mm from edge of rear window aperture.
Dimension (B) = 290 mm from end of gutter.
Support the roof.
Cut through C-pillar along cutting line.
Define separating point in cover for side member and mark out.
Dimension (A) = 110 mm (measured from edge to cover on side
member).
RA Replacing complete rear left wheel arch
BMW AG - TIS
18.02.2013 02:05
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
