7 Series E38 750i (M73) SAL
Remove left or right reinforcement and heat shield.
Remove positive lead on support point.
If applicable, unfasten oil line from front axle support.
Warning!
Release bolt connection of front axle support from side of car
- no personnel are permitted to stand underneath the front
axle!
Danger of injury!
Attach workshop hoist with special tool 31 2 220 and front axle
support.
Unscrew left and right bolts.
Installation:
Tightening Torque,
refer to Technical Data 31 10 1AZ.
Unscrew left and right nuts.
If applicable, disconnect plug connection for electronic damper
control (EDC).
Lift off cap and remove from cable.
Installation:
Replace self-locking nuts.
Tightening Torque,
refer to Technical Data 31 31 1AZ.
RA Removing and installing complete front axle (with spring strut shock absorber)
BMW AG - TIS
19.02.2013 16:53
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
