7 Series E38 750i (M73) SAL
Bleed rear-axle brake circuit
Connect bleeder hose with container to bleed valve on rear right
brake caliper.
Open bleed valve.
Run bleeding routine with BMW Diagnosis and Information
System (DIS) with bleeder valve opened.
After running routine, press brake pedal 5 times to stop; clear,
bubble-free brake fluid must flow out.
Close bleeder valve.
Repeat procedure at rear left.
Bleed front-axle brake circuit
Push bleeder hose with container to the bleeder valve on the front
right brake caliper.
Open bleed valve.
Run bleeding routine with BMW Diagnosis and Information
System (DIS) with bleeder valve opened.
After running routine, press brake pedal 5 times to stop; clear,
bubble-free brake fluid must flow out.
Close bleeder valve.
Repeat procedure at front left.
Switch off bleeder unit and disconnect from expansion tank.
Check brake fluid level.
Close expansion tank.
Note:
Take care of rubber gasket (1) in lid.
RA Bleeding brake system with DSC3 from 09/97, 750i/iL to 09/98
BMW AG - TIS
19.02.2013 18:22
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
