7 Series E38 750i (M73) SAL
Mark cutting line and cut off engine carrier.
Dimension (A) = max. 35 mm.
Cut off new engine carrier to size to match cut on car and fit in.
Clean mating surfaces and drill holes for plug welding.
Clean engine carrier connection and drill holes for plug welding.
Align connection faces for drier flask bracket and grind down, then
coat with zinc dust paint.
Produce reinforcement plates with width (B) of about 60 mm and
coat with zinc dust paint.
Insert reinforcement plates half their width into engine carrier and
plug weld.
RA Replacing right engine carrier (partial replacement in front of front axle)
BMW AG - TIS
19.02.2013 19:54
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
