7 Series E38 750iL (M73) SAL
12 14 519
Replacing impulse sensor (cylinder bank 1-6)
(M73)
Remove DME control unit fault memory.
Switch off ignition.
Remove rear splash guard.
Disconnect plug connection of impulse sensor on crankshaft
(flywheel) for the DME 1 (cylinder 1-6).
Unscrew screw. Remove pulse sensor.
Installation:
Observe the following when replacing the transmission, the
flywheel or the pulse sensor:
Note whether one or more shims are installed between the
transmission housing and the pulse sensor. If one or more
shims are installed, the distance between the pulse sensor
and the pulse teeth of the increment wheel must be
measured.
Turn the engine on the front central bolt so that a full pulse tooth
(1) can be seen through the opening of the removed pulse sensor.
Make sure that the pulse tooth (1) is exactly centred in the hole.
RA Replacing impulse sensor (cylinder bank 1-6) (M73)
BMW AG - TIS
20.02.2013 19:03
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
