7 Series E38 750iL (M73) SAL
Bleeding rear-axle brake circuit
Connect bleeder hose and bottle to bleed valve on rear right brake
caliper.
Open bleed valve.
Run bleeding routine with BMW Diagnosis and Information
System (DIS) with bleeder valve opened.
After routine is completed, press brake pedal 5 times down to
floor; clear bubble-free brake fluid must emerge.
Close bleeder valve.
Repeat procedure at rear left.
Bleeding front-axle brake circuit
Push bleeder hose with container onto the bleeder valve on the
front right brake caliper.
Open bleed valve.
Run bleeding routine with BMW Diagnosis and Information
System (DIS) with bleeder valve opened.
After routine is completed, press brake pedal 5 times down to
floor; clear bubble-free brake fluid must emerge.
Close bleeder valve.
Repeat procedure at front left.
Switch off bleeder unit and disconnect from expansion tank.
Check brake fluid level.
Close expansion tank.
Note:
Take care of rubber gasket (1) in lid.
RA Bleeding brake system with DSC3 750i/il from 09/96 to 09/98
BMW AG - TIS
20.02.2013 22:22
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
