7 Series E38 L7 (M73) SAL
12 71 530
Removing and installing / replacing control
unit for Electronic Engine Power Control
(EML) (M73)
Important!
Follow instructions for removal and installation of electronic
control units!
refer to General Information MG 12
Switch off ignition.
Unfasten screws.
Tightening torque,
refer to Technical Data 12 14 4AZ
Remove cover from control unit box.
Control unit (1) (DME 1): disconnect plug connection and remove
control unit from bracket.
Control unit (2) (DME 2): disconnect plug connection and remove
control unit from bracket.
Control unit (3) for Electronic Transmission Control (EGS)
Control unit (4) for Electronic Engine Power Control (EML)
For subsequent procedure during exchange of control units, refer
to DIS.
Unfasten plug connection from all control units.
Remove control unit (4) from bracket.
Interrogate fault memory of control unit for Digital Motor
Electronics (DME), check error messages in memory, rectify faults
and clear fault memory.
RA Removing and installing / replacing control unit for Electronic Engine Power Con
BMW AG - TIS
21.02.2013 23:50
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
