bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

3 RA Draining And Filling Fuel Tank|Page 861 > < 2 RA General Function Description For Fuel Supply Systems
Page 1
background image

16 00 005

Draining and filling fuel tank

Caution!

Observe relevent country safety legislation and regulations!

Ensure adequate ventilation in the place of work!

Connect the exhaust and extraction systems to the exhaust
tailpipe.

The electric fuel pump must not operate without fuel! After
servicing before the first engine start-up, fill the fuel tank via
the fuel filling line with at least 5 l fuel.

Note:

The fuel tank has two tube necks for draining off fuel.

The right neck, facing in direction of travel, leads into inside of
tank to right side of tank.

Both tube necks are linked together with a section of hose which
seals them from outside.

M57

On the M57, only the right connection viewed in the direction of
travel is available for drawing off since the left connection for the
auxiliary heater/independent heating also leads to the right half of
the tank. Connect suction extractor unit, draw off right half of tank.
Then start engine and run for approx. 20 seconds in order to
activate suction jet pump. Draw off remaining fuel.

Remove left stone chip guard.

Unfasten both connections with special tool 13 3 010.

RA  Draining and filling fuel tank

BMW AG - TIS

22.02.2013  00:08

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 1 -

3 RA Draining And Filling Fuel Tank|Page 861 > < 2 RA General Function Description For Fuel Supply Systems