7 Series E38 L7 (M73) SAL
Prepare the reinforcement plate from the scrap sheet metal.
Width of the reinforcement plates: approx. 60 mm
Overlapping: approx. 30 mm each.
Align the reinforcement plates.
Drill the holes for the plug welding at each joint surface.
Coat the joint surfaces on the body and the reinforcement plates
with zinc dust paint.
Align, fasten and weld the front reinforcement plate.
Align, fasten and weld the rear reinforcement plate.
RA Replacing left or right side member cover (partial replacement of A-column and r
BMW AG - TIS
22.02.2013 04:14
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
