7 Series E38 L7 (M73) SAL
Release screws (1) with toothed washers (2) on left/right.
Remove cup holder (3) from function carrier (4).
Installation:
Insert cup holder (3) and initially tighten screws (1) with
toothed washers (2) on left/right, do not tighten down fully.
Align cup holder in correct position and tighten down screws
(1) on left/right.
Tightening Torque,
refer to Technical Data 51 16 6AZ.
Installation:
Insert retaining strap (1) in support (2).
Install retaining rings (3) if necessary.
RA Removing and installing/replacing front cup holder
BMW AG - TIS
22.02.2013 05:06
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
