7 Series E65 730d (M57T2) SAL
Unlock tab (1), pull contact carrier (2) in direction of arrow out of
housing.
Unlock plug (1) and remove.
Release screws on cable duct (1).
Work step
Note:
Unlock plug on lambda oxygen sensor and disconnect
Unlock plug on diesel particulate filter temperature sensor and disconnect
Unlock plug on exhaust system pressure sensor and disconnect
Unlock plug on A/C compressor and disconnect
Release nut and disconnect control line from starter motor
Unlock plug on crankshaft sensor and disconnect
Unlock plug on coolant temperature sensor and disconnect
Unlock plugs of all glow plugs and disconnect
Unlock plug on camshaft sensor and disconnect
Unlock plug on air mass sensor and disconnect
RA Replacing wiring harness section for engine (M57T2)
BMW AG - TIS
02.02.2013 16:21
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
