7 Series E65 730d (M57T2) SAL
34 41 135
Removing and installing or replacing both
Bowden cables for parking brake
Important!
Read and comply with General Information.
With mechanical emergency release of actuating unit, max.
torque at end stop 5 Nm.
Bowden cables may only be replaced in pairs.
Observe safety instructions on raising the vehicle.
Necessary preliminary tasks:
•
Remove both rear wheels
•
Remove brake disks
•
Disconnect parking brake Bowden cables from wheel brake
•
Unscrew holder for Bowden cables from body
•
Remove luggage compartment floor trim panel
•
E67:
Remove starter battery
Release screws on parking brake housing cover and remove
housing cover.
Installation:
Tightening torque 34 41 2AZ
.
RA Removing and installing or replacing both Bowden cables for parking brake
BMW AG - TIS
02.02.2013 19:43
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
