7 Series E65 730d (M57T2) SAL
(R) From brake master cylinder, circuit R, to hydraulic unit, circuit
R (rear-axle brake circuit)
(FR) From hydraulic unit FR to wheel brake, front right
(FL) From hydraulic unit FL to wheel brake, front left
(RR)From hydraulic unit RR to wheel brake, rear right
(RL) From hydraulic unit RL to wheel brake, rear left
Unlock plug connection (1) in direction (2) and detach vertically
upwards.
Installation:
Position plug connection (1) vertically on control unit in order
to avoid damaging pins.
Disconnect plug connection (4).
Release screw (5) and remove hydraulic unit.
The following components must be modified when the hydraulic
unit is replaced:
-
Pressure sensor
-
Hydraulic unit bracket
When replacing control unit:
-
Carry out programming/coding
-
Adjustment of steering angle sensor
-
Mix-up check of brake lines
-
Function check, hydraulic unit
RA Removing and installing/replacing DSC hydraulic unit
BMW AG - TIS
02.02.2013 19:46
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -