7 Series E65 730d (M57TU) SAL
Note:
Clean sealing face of cylinder head and engine block.
Remove gasket remnants with hardwood spatula.
If the piston clearance is changed (e.g. replacing piston)
the cylinder head gasket thickness must be recalculated.
Note:
Joints between timing case cover and engine block are sealed
with sealing strips stuck on as standard.
It is not necessary to apply a permanently elastic sealing
compound.
Check dowel sleeve (1) for damage and replace if necessary.
Transitions (2) must be absolutely free of grease.
Fit new cylinder-head seal.
Carefully fit cylinder head.
Fit new cylinder head screws.
Tighten down the cylinder-head bolts in order 1 ... 14.
Tightening torque 11 12 7AZ
.
RA Removing and installing cylinder head (M57TU)
BMW AG - TIS
04.02.2013 00:31
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
