7 Series E65 730d (M57TU) SAL
Before installing injectors, clean injector stems.
DDE 4
If more than 2 injectors have been replaced, "injector map
adjustment" must be carried out:
-
Connect DIS Tester
-
Identify car
-
Select "Function selection"
-
Select "Service functions"
EU3 / DDE 5 only
The first 6 numbers/letters must be read off in each case when
new injectors are installed.
Enter the numbers/letters according to the installation location
(cylinder) of the new injectors.
-
Select "Digital Diesel Electronics" (DDE)
-
Select "Adjustment, injector quantity adjustment"
-
Select "Test schedule"
-
Select "Carry out adjustment". The adjustment values are
thus set to neutral.
EU4 / DDE 5 only
The first 7 numbers/letters must be read off in each case when
new injectors are installed.
Enter the numbers/letters according to the installation location
(cylinder) of the new injectors.
-
Select "Diesel Electronics" (DDE)
-
Select "Adjustment, injector quantity adjustment"
-
Select "Test schedule"
-
Select "Carry out adjustment". The adjustment values are
thus set to neutral.
-
Select "Adaptations, quantity mean value adaptation".
RA Removing and installing/replacing all injectors of injection system (M57 / M57TU
BMW AG - TIS
04.02.2013 01:41
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -