7 Series E65 730d (M57TU) SAL
33 31 011
Replacing rear axle carrier
Important!
Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic system.
Close off pipe connections with plugs.
Necessary preliminary tasks:
•
Remove rear differential
•
Remove complete rear axle carrier and if necessary with
other workers assisting set down on a suitable surface
•
Version with Dynamic Drive: Disconnect pressure lines for
oscillating motor of rear axle from rear axle carrier
•
Remove both stabilizer links from stabilizer
•
Remove stabilizer from rear axle carrier
•
Remove ride-height sensor(s) with holder from rear axle
carrier
Remove swinging arm on both sides from rear axle carrier.
Remove control arm on both sides from rear axle carrier.
Remove guide arm on both sides from rear axle carrier.
Remove wheel carrier on both sides with output shaft, swinging
arm and suspension arms.
Build date up to 03/2005:
Note:
If the rear axle carrier is to be replaced, the parts also ordered
(see graphic) must be installed. The procedure is described in the
document "... tension strut for rear axle carrier".
RA Replacing rear axle carrier
BMW AG - TIS
04.02.2013 04:17
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
