7 Series E65 730d (M57TU) SAL
33 33 001
Replacing left or right rear axle carrier tension
strut
Important!
Observe safety instructions for raising the vehicle
Driving without compression struts is not permitted!
Risk of damage!
The rear axle carrier must be supported at the front is both
tension struts have to be replaced!
Necessary preliminary tasks:
•
Remove rear lip
•
Version with Dynamic Drive: Disconnect pressure lines for
oscillating motor of rear axle from tension strut.
Release screw (1).
Tightening torque 33 32 28AZ
.
Remove heat shield (2) from clip (3) on fuel tank retaining strap.
Installation:
Check clip (3) for damage and replace if necessary.
Release screws (1).
Tightening torque 33 32 17AZ
.
Release screw (2) and remove tension strut (3).
Secure rear axle carrier by inserting screw (2).
Installation:
Check threads for damage; if necessary, repair with Helicoil thread
inserts.
Tightening torque 33 33 3AZ
.
RA Replacing left or right rear axle carrier tension strut
BMW AG - TIS
04.02.2013 04:22
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
