7 Series E65 730d (M57TU) SAL
Assemble special tool 33 4 140 with 33 4 148 and
33 4 149 .
Unscrew feed handle (1). If necessary, mount extension
piece (3) on special tool 33 4 145 with new screw (2).
Rubber mount, front, only: Release screw.
Fit special tools 33 4 140 , 33 4 155 , 33 4 156 , 33 4 158
on openings in rubber mount.
Note:
Ensure it is correctly supported on bush of rear axle support.
Using a hot air blower, heat bearing bushing at max. 600
°
C outlet
temperature for approx. 2 minutes.
Pull out rubber mount by turning special tool 33 4 155 .
Coat rubber mount with Circolight anti-friction agent.
Important!
Arrows (1) or stops (2) of inner sleeve must point in vehicle
longitudinal direction (F) when rubber mount is installed. A
maximum deviation (A) of
±
7
°
must be observed.
RA Replacing all rubber mounts for rear axle carrier
BMW AG - TIS
04.02.2013 04:22
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -