7 Series E65 730d (M57TU) SAL
Disconnect plug connections (1, 2).
Remove grounding strap (3) from valve block.
Release screws (4).
Tightening torque 37 14 17AZ
.
Raise valve block and remove towards front.
Disconnect all plug connections (1) on valve block.
Unclip wiring set from valve block.
After installation:
•
Fill and bleed hydraulic system
•
Check pipe connections for leaks
•
If necessary, carry out initial Dynamic Drive operation
RA Removing and installing/replacing DYNAMIC DRIVE valve block
BMW AG - TIS
04.02.2013 05:34
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -