7 Series E65 730d (M57TU) SAL
Note:
Hydraulic fluid (4) seeps into fluid tank (6) through two bores
under deep-groove ball bearing (2).
Fill hydraulic fluid (4) between cylinder star (5) and deep-groove
ball bearing (2).
Lift pump carrier (3) several times at valve (1), air escapes from
fluid tank (6) more quickly.
Set pump carrier (1) down on a horizontal surface (3).
Damper (4) and valve (2) must not rest on surface.
Fluid level (2) must be in upper area (A) of marking (5), correct if
necessary.
When ideal filling is achieved:
Connect hydraulic unit in vehicle to hydraulic hoses.
Close rear lid (motor-driven) twice and open again, this bleeds the
system.
Hold hydraulic unit with drive (1) all round vertically upwards.
Fluid level (2) must be in area (A) of marking (3) with rear lid fully
open (cylinder retracted).
RA Correcting fluid level in hydraulic unit for rear lid actuation (electrohydrauli
BMW AG - TIS
04.02.2013 07:51
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
