7 Series E65 730d (M57TU) SAL
Installation of rubber frame without removed windscreen:
There is no tear-off lip (3) in area (A) on left/right.
Detach tear-off lip (3) from rubber frame (1).
If adhesive leaks over tear-off lip (3), this area must be cut out
partially.
To facilitate installation, coat rubber frame (1) and body cutout
with water.
Install rubber frame (1).
If necessary, pull liner* off adhesive tape (5) and press rubber
frame (1) down firmly on roof outer skin.
2
Aluminium strip
4
Butylene tape
* Liner is the protective film on adhesive tape (5).
Installation of rubber frame with removed or new windscreen:
There is no tear-off lip (3) in area (A) on left/right.
Fit rubber frame (1) with tear-off lip (3).
After installing windscreen: If necessary, pull liner* off adhesive
tape (5) and press rubber frame (1) down firmly on roof outer
skin.
2
Aluminium strip
4
Butylene tape
* Liner is the protective film on adhesive tape (5).
RA Removing and installing / replacing rubber frame for windscreen (top)
BMW AG - TIS
04.02.2013 07:54
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -