7 Series E65 740d (M67) SAL
Installation:
- Replace gasket (1).
- Clean sealing faces.
Release screws (1).
Disconnect pressure lines (2).
Tightening torque,
refer to Technical Data 11 53 8AZ .
Remove pressure accumulator (3).
Disconnect plugs from pre-glow elements.
Detach line (1).
Lay hose (2) upwards.
Tie engine wiring harness (3) back.
Release clamp (1).
Tightening torque,
refer to Technical Data 11 71 1AZ .
Note:
EGR pipe remains on cylinder head.
Release clamp (3).
Remove hose (4).
RA Removing and installing left cylinder head (M67)
BMW AG - TIS
09.02.2013 13:53
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
