7 Series E65 740d (M67) SAL
Note:
The left cylinder head is shown here.
Release microencapsulated bearing pin (1) of guide rail on
cylinder head at front.
Tightening Torque,
refer to Technical Data 11 31 12AZ.
Installation:
Replace bearing pin.
Note:
For removal, rear right cylinder head bolt (1) must remain in
cylinder head.
Caution!
The glow plugs protrude at the sealing face of the cylinder
head and can be damaged when set down.
Remove cylinder head.
If necessary, remove glow plugs with special tool 11 6 050.
Note:
Special tools 11 6 050 delivered before 04/1998 should be
drilled out at 9.5 mm dia. 20 mm deep.
Tightening Torque,
refer to Technical Data 12 23 2AZ.
RA Removing and installing right cylinder head (M67)
BMW AG - TIS
09.02.2013 13:54
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
