7 Series E65 740d (M67) SAL
Installation:
Replace O-ring (1) if damaged.
Caution!
Do not mix up three bearing pins (1).
Bearing pins (1) are microencapsulated and must be
replaced.
Release bearing pin (1).
Tightening Torque,
refer to Technical Data 11 31 12AZ.
Note:
For purposes of clarity, the bearing pins are still installed in
this illustration.
Remove tensioning rail (1).
Remove guide rail (2).
Lay timing chain (3) of cylinders 5 - 8,
timing chain (4) of cylinders 1 - 4,
drive chain (5) of oil pump so that crankshaft sprocket wheel can
be pushed out forwards.
Push out crankshaft sprocket wheel forwards.
Installation:
Check spring washer (1) and replace if damaged.
Check spring washer (1) for correct seating.
RA Replacing both timing chains (M67)
BMW AG - TIS
09.02.2013 14:14
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
