7 Series E65 740d (M67) SAL
Raise wiring harness (1).
Disconnect water pipe (2).
Note:
- Do not damage cover (1) of full flow oil filter.
- Release and tighten down with a socket only.
- When the full flow oil filter cover (1) is released, the oil flows
back into the sump.
Release full flow oil filter cover (1) and remove by pulling upward.
Remove oil filter element.
Tightening torque, 11 42 2AZ
.
Installation note:
Replace sealing rings and coat with oil.
E38 only:
Release clamps (1).
Detach vent hoses (2).
RA Removing and installing, sealing or replacing full flow oil filter (M67)
BMW AG - TIS
09.02.2013 14:20
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
