7 Series E65 740d (M67) SAL
Loosen screws (1).
Disconnect EGR pipe (2).
Installation note:
Clean sealing surfaces.
Replace seals on EGR pipes.
Loosen screws (1).
Installation note:
Observe standard tightening torque of M7 screws.
Raise water pipe (1) a little.
Withdraw water pipe (1) from thermostat housing (2) and remove.
Installation note:
Check seal in thermostat housing (2).
If necessary, replace sealing ring.
RA Replacing oil strainer for engine breather (M67)
BMW AG - TIS
09.02.2013 14:35
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
