7 Series E65 740d (M67) SAL
Caution!
A small amount of engine oil emerges when the oil pressure
switch is removed.
Have a cleaning cloth ready.
Raise engine wiring harness (1).
Disconnect plug connection.
Remove oil pressure switch.
Installation note:
Replace sealing ring.
Tightening torque, 12 61 1AZ
.
Reassemble car and set in horizontal position.
Start engine and run at idle until oil indicator lamp goes out.
Switch off engine. Wait approx. 5 minutes and then check engine
oil level.
Top up engine oil if necessary.
RA Removing and installing/replacing oil pressure switch (M67)
BMW AG - TIS
09.02.2013 15:08
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -