7 Series E65 740d (M67) SAL
Note:
If sealing ring (1) of injector (2) remains in cylinder head:
-
Remove sealing ring
-
Replace sealing ring
Common rail, 1st generation (E38 only)
Note:
If more than 3 injectors have been replaced, "injector map
adjustment" must be carried out:
1.
Connect DIS Tester
2.
Identify car
3.
Select "Function selection"
4.
Select "Service functions"
5.
Select "Digital Diesel Electronics (DDE)"
6.
Select "Injector map adjustment"
7.
Select "Test schedule"
8.
Select "Carry out adjustment". The adjustment values are
thus set to zero.
Common rail, 2nd generation (E65 only)
EU3: 6-figure code, EU4: 7-figure code
The first 6 or 7 numbers/letters must be read off in each case
when new injectors are installed.
RA Removing and installing/replacing all injectors in fuel injection system (M67)
BMW AG - TIS
09.02.2013 15:22
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -