7 Series E65 740d (M67) SAL
51 14 110
Removing and installing/replacing rear model
designation (BMW ALPINA B7)
Important!
The "Instructions for number/letter combination cementing"
serve as the basis for these repair instructions and must be
followed without fail.
Stick on top edge of adhesive tape (1) parallel to trim (2) on rear
lid at distance (A).
Mark measurement (B) on top edge of adhesive tape (1).
Remove liner (protective strip for adhesive surface).
Position lettering against adhesive tape (1) and press down
firmly.
Dimensions:
A = 10 mm
B = 30 mm
Stick on top edge of adhesive tape (1) parallel to trim (2) on rear
lid at distance (A).
Mark measurement (B) on top edge of adhesive tape (1).
Remove liner (protective strip for adhesive surface).
Position lettering against adhesive tape (1) and press down
firmly.
Dimensions:
A = 10 mm
B = 50 mm
RA Removing and installing/replacing rear model designation (BMW ALPINA B7)
BMW AG - TIS
09.02.2013 22:38
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
