7 Series E65 740d (M67) SAL
51 14 110
Removing and installing/replacing rear model
designation (from 03/2005)
Important!
The "Instructions for number/letter combination cementing"
serve as the basis for these repair instructions and must be
followed without fail.
Fitting dimensions (E65, E66, E67):
Attach adhesive tape (1) to rear lid above trim strip (2) up to top edge "A". Mark measurement "B" from outermost
corner point of trim strip (2) on adhesive tape (1).
Dimensions:
A = 22 mm
B = 25 mm
Note:
Measurements C, D, E and F are for information purposes only, as determined by carrier film.
C = 8 mm, D = 10 mm, E = 16 mm, F = 26 mm
RA Removing and installing/replacing rear model designation (from 03/2005)
BMW AG - TIS
09.02.2013 22:38
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
