7 Series E65 740d (M67) SAL
67 31 530
Removing and installing/replacing drive unit
for backrest angle adjustment
Necessary preliminary tasks:
•
Remove front seat.
•
Remove rear panel on front seat backrest.
•
Remove covers on front seat.
Unhook backrest cover (1) on left and right on backrest
frame (2).
Remove metal retaining ring (1) in direction of arrow from drive
rod (2).
Installation:
Always replace metal retaining ring (1).
Make sure metal retaining ring (1) is correctly seated.
Release screw (3).
Disconnect plug connection (4).
Pull out drive rod (1) until drive unit for backrest angle
adjustment (2) is free.
Installation:
Make sure drive rod (1) is correctly seated in drive unit for
backrest angle adjustment (2).
Feed drive unit for backrest angle adjustment (2) out of backrest
frame (3) and remove.
RA Removing and installing/replacing drive unit for backrest angle adjustment
BMW AG - TIS
10.02.2013 06:54
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
