7 Series E65 740d (M67) SAL
Note:
Temperature of vehicle roof and multiband telephone antenna
must be at least 18
°
C.
Clean bonding surfaces with spirit and leave to dry (air drying time
at least 1 minute).
After this, do not touch bonding surfaces any more.
Note:
Double-sided adhesive tape (1) is provided with both enclosed
and perforated protective film.
Pull off enclosed protective film from double-sided adhesive
tape (1).
Stick double-sided adhesive tape (1) as illustrated from rear side
to tip centrally onto multiband telephone antenna (2).
Feed in antenna leads (1) using previously pulled-in cord or
wire (2) and connect plug connections.
Pull off perforated protective film (1).
Note:
Do not touch bonding surface of multiband telephone
antenna (2).
Mount multiband telephone antenna (2) so that positionings (3)
can slide simultaneously into holes (4).
Place multiband telephone antenna (2) in position.
Note:
Change position of multiband telephone antenna (1) max. three
times so as not to impair adhesive effect of adhesive.
Press down telephone antenna (1) at small intervals (1-2 cm) all
round with firm thumb pressure.
RA Removing and installing/replacing multiband telephone antenna
BMW AG - TIS
10.02.2013 07:52
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -