7 Series E65 740i (N62TU) SAL
Important!
Intermediate levers (2) are divided into individual tolerance
classes.
Only intermediate levers of the same tolerance class may be
fitted in a single cylinder head.
The tolerance classes are designated as illustrated with the
numbers from 1 to 5.
Used intermediate levers (2) may only be reused in the same
position.
Raise second end of torsion spring (1) with special tool
11 9 480 .
Lift out intermediate lever (2) and set down in an orderly fashion.
Important!
Keep holding torsion spring (1) with special tool 11 9 480 .
Attach special tool 11 9 490 to second end of torsion spring.
Support end of torsion spring protected with special tool
11 9 490 on inlet camshaft.
Installation
Removal of intermediate levers is described separately from
installation.
Clean all bearings and cams of inlet camshaft and lubricate with
engine oil.
RA Removing and installing/replacing right intermediate levers (N62 from 9/03 and N
BMW AG - TIS
11.02.2013 02:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
