7 Series E65 740i (N62TU) SAL
Note:
A gasket (2) is installed between cylinder head and slide rail (1).
Replace gasket (2) and preinstall on slide rail (1).
Install slide rail (1) with gasket, insert screw and tighten down.
Rotate exhaust camshaft against direction of rotation until cam on
1st cylinder points upwards at an angle as shown in graphic.
Install inlet and exhaust adjustment unit on right side.
Install spark plugs on cylinder bank 1 to 4.
Install right cylinder head cover.
Install ignition coils on cylinder bank 1 to 4.
Assemble engine.
RA Removing and installing/replacing right exhaust camshaft (N62/N62TU)
BMW AG - TIS
11.02.2013 02:23
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -
