7 Series E65 740i (N62TU) SAL
Important!
Do not tilt bearing bracket (1).
Carefully lift out bearing bracket (1).
Place bearing bracket (1) with inlet camshaft and eccentric shaft
as illustrated on special tool 11 9 470 .
Secure bearing bracket (1) with a nut (special tool 11 9 473 ).
Important!
The lower section of the bearing bracket (1) is machined with
the cylinder head and must not be mixed up.
Note:
Lower section of bearing bracket (1) remains on cylinder head.
Important!
Rocker arms (1) are divided into individual tolerance classes.
The tolerance classes are designated as illustrated with the
numbers from 1 to 4.
Used rocker arms (1) may only be reused in the same
position.
Remove rocker arms (1) on inlet side and set aside in neat order.
RA Removing and installing/replacing rocker arms on left inlet side (N62 from 9/03
BMW AG - TIS
11.02.2013 02:30
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
