7 Series E65 740i (N62TU) SAL
Rotate inlet camshaft in direction of rotation until cam on 1st
cylinder is positioned horizontally as shown in illustration.
Important!
Camshaft bearing caps of cylinders 1 to 4 and 5 to 8 must
not be mixed up.
Note:
Bearing caps of inlet camshaft are marked on cylinder bank 1
to 4 with L E1 to L E5 from inlet side.
Release nuts and remove bearing cap L E1.
Release 8 nuts of bearing bracket (1) from outside to inside.
Clamp special tool 11 9 470 as illustrated in a vice.
RA Removing and installing/replacing rocker arms on right inlet side (N62 from 9/03
BMW AG - TIS
11.02.2013 02:30
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
