7 Series E65 740i (N62TU) SAL
Insert bearing shells (1) into bearing bracket so that it is secured
in bore (2).
Lubricate bearing shells (1) with engine oil.
Cylinder bank 1 to 4:
Important!
The machined curvature (1) of the eccentric points inwards.
The magnet wheel (2) is at the rear.
Install eccentric shaft as shown in graphic.
Lubricate bearing shells (1) with engine oil.
Install bearing shells (1).
RA Removing and installing/replacing right eccentric shaft (N62 from 9/03 and N62TU
BMW AG - TIS
11.02.2013 02:40
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -