7 Series E65 740i (N62TU) SAL
Unfasten screws.
Rotate servomotor (2) until no longer engaged in spline teeth of
eccentric shaft.
Installation:
Replace sealing ring on spacer.
Install servomotor (1) and screw in up to spacer.
Rotate servomotor (1) into correct installation position.
Install and tighten down screws.
Installation:
Read out fault memory of control unit of Digital Motor Electronics
(DME).
Check stored fault messages.
Rectify faults.
Now clear the fault memory.
RA Removing and installing/replacing servomotor for left eccentric shaft (N62/N62TU
BMW AG - TIS
11.02.2013 02:42
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
