7 Series E65 740i (N62TU) SAL
12 14 611
Replacing left knock sensors (N62, N62TU)
(cylinder bank 5 to 8)
Necessary preliminary tasks:
•
Read out fault memory of DME control unit
•
Check stored fault messages
•
Switch off ignition
•
Remove intake air manifold
Important!
Mixing up the knock sensor plug connections will result in
engine damage!
Routing of wires and plug connections must conform to the
original routing. This eliminates the risk of confusion and mix-
ups.
Release bolts.
Tightening torque 12 14 1AZ
.
Remove knock sensors (1).
RA Replacing left knock sensors (N62, N62TU)
BMW AG - TIS
11.02.2013 03:15
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
