7 Series E65 740i (N62TU) SAL
Important!
Upper coil of coil spring must rest positively on spring plate!
Lower end of coil spring must rest on stop of spring pad!
Relieve tension on coil spring.
Check installation position of gaiter, correct fold if necessary.
After installation:
•
Carry out wheel alignment check if a spring strut with support
bearing was or has been installed without centering pin.
•
Carry out coding (dependent on type code number)
Note:
Coding is only required on listed vehicles from 03/2005 with
Electronic Damper Control (EDC).
RA Replacing front left or right spring strut (standard suspension, build date from
BMW AG - TIS
11.02.2013 04:57
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
