7 Series E65 740i (N62TU) SAL
33 32 064
Removing and installing/replacing left or right
swinging arm
Important!
Observe safety instructions on raising the vehicle.
Note:
If the swinging arm is detached from the integral link/wheel carrier
or rear axle carrier, it is necessary after reinstallation to carry out a
wheel/chassis alignment check.
Necessary preliminary tasks:
•
Remove rear wheel
•
Remove jointed rod of ride-height sensor from swinging arm
•
Remove stabilizer link from swinging arm
Mark position of eccentric screw to rear axle carrier.
Support wheel carrier with workshop jack.
Release nut (1) and remove eccentric washer (2).
Remove eccentric screw towards front.
Installation:
Note insertion direction of eccentric screw.
Align eccentric screw by means of marking to rear axle carrier.
Refit eccentric washer.
Replace self-locking nut.
Tighten bolt connection in normal position.
RA Removing and installing/replacing left or right swinging arm
BMW AG - TIS
11.02.2013 06:35
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -