bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

4 RA Removing And Installing _ Replacing Rear Left Or Right Air Spring Strut|Page 1406 > < 3 RA Carrying Out Ride-height-calibration
Page 1
background image

37 12 070

Removing and installing / replacing rear left
or right air spring strut

Warning!

Danger of injury!

Drain the air spring system before carrying out any work on
the air supply unit, air pipes and air spring struts! Danger of
injury if this instruction is not complied with!

 

Risk of damage!

Extreme cleanliness must be ensured in the connection area
of the pipes during removal and installation. Even the smallest
of dirt particles can cause leakage in the air spring system.

Note:

Read and comply with notes on air spring system.

In a warranty case you must always provide a fault memory
printout, even where there is no fault memory entry, with the
defective part.

Necessary preliminary tasks:

Deactivating air spring system:

Raise vehicle on lifting platform.

Remove ignition key.

Pull fuse for control unit

Remove rear wheel arch cover

Warning!

Danger of injury!

Do not disassemble the air spring strut! Air spring strut is still
under a certain residual pressure even after the pipe is
disconnected.

Important!

Risk of damage!

Grip residual pressure holding valve when releasing and
tightening banjo bolt in order to avoid leaks at the air spring
strut.

RA  Removing and installing / replacing rear left or right air spring strut

BMW AG - TIS

11.02.2013  08:00

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 1 -

4 RA Removing And Installing _ Replacing Rear Left Or Right Air Spring Strut|Page 1406 > < 3 RA Carrying Out Ride-height-calibration